This INAV compatible Matek F411-Wing FC is a great option for your fixed wing or airplane.
SPECIFICATIONS:
- MCU: 100MHz STM32F411
- IMU: MPU6000 accelerometer/gyro (SPI)
- Baro: BMP280 (I2C)
- OSD: INAV OSD w/ AT7456E chip
- Blackbox: No
- VCP & 2x UARTs
- 2x Motors, 5x Servos outputs
- 1x I2C
- 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red)
- Built-in inverter for SBUS input (UART1-RX)
- SoftSerial_Tx1: ST1 pad by default
- PPM: ST1 pad with softserial disabled
- Battery Voltage Sensor: 1:10 (Scale 1100)
- WS2812 Led Strip: Yes
- Beeper: Yes
- RSSI: No
FC FIRMWARE:
- INAV Flight
- Target: MATEKF411
PDB:
- Input voltage range: 6.5~30V (2~6S LiPo) w/TVS protection
- 2x ESC power pads
- Current Senor: 78A, 3.3V ADC, Scale 423
BEC 5V OUTPUT:
- Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed
- Continuous current: 2 Amps
BEC VX OUTPUT:
- Designed for Servos
- Voltage adjustable, 5V Default, 6V via jumper
- Continuous current: 3 Amps
- BEC 3.3V output
- Designed for Baro / Compass module/ OLED and Spektrum RX
- Linear Regulator
- Continuous current: 200mA
PHYSICAL:
- Mounting: 24 x 24mm, Φ2mm
- Dimensions: 41 x 28 x 10mm
- Weight: 7g (Total 12g w/ bottom plate and M2 standoffs)
AVAILABLE TARGETS:
- MATEKF411 if you want to control LEDs and have SS1 TX on ST1 pad.
- MATEKF411_FD_SFTSRL if you need the softserial to be full-duplex (TX = ST1 pad, RX = LED pad), at the cost of losing the LED output.
- MATEKF411_RSSI if you want to have analog RSSI input on ST1 pad. SS1 TX will be available on the LED pad.
- MATEKF411_SFTSRL2 if you want to use two softserials (TX only) at the same time. Eg. Smart Audio + S. Port, Smart Audio + LTM