Mobula7 HD Brushless Micro FPV Drone (2-3S / BNF / Frsky)

Regular price $159.99

The Happymodel Mobula7 HD "cinewhoop" has arrived! With its built-in Caddx Turtle V2 cam, the Mobula7 HD will record high-quality HD footage, while the new CrazyBee F4 AIO FC which supports up to 3S will give you the power you need!

Attention: These drones come flashed with a custom firmware from the manufacturer to provide optimal performance. Updating the firmware may cause undesirable results, including bricking the board. If an update has already been done, then click here to obtain the correct firmware.

Specifications:

  • Wheelbase: 75mm
  • Size: 98mm*98mm*45mm
  • Weight: 48g(without battery)
  • New Crazybee F4 PRO V2.0 AIO Flight controller 1-3s Lipo Compatible (2S for indoor Cine whoop mode) or (3S for outdoor Freestyle whoop mode)
  • The lightest 1102 brushless motor only 2.7g with double ball bearings
  • Betaflight OSD support, easy to get RSSI, Voltage, Current from your goggles
  • Caddx turtle v2 + 1080p 60fps DVR ready
  • Camera Angle adjustable
  • VTX power switchable 25mw~200mw
  • Smart audio ready, change VTX bands, powers, channels via OSD
  • Frsky Non-EU version (D8/D16 compatible)
  • Full telemetry function ready

Attention:

  • Make sure the VTX antenna is properly connected before applying power to the drone.
  • In order to reduce risk from the Mobula7 HD (10000kv motor version) from burning your ESCs while using the stock 3S battery, we suggest limiting your throttle to 75%. Doing this will provide almost the same performance as the new KV9000 version.
    • The cli command is :
      set throttle_limit_type = scale
      set throttle_limit_percent = 75
      save

Specifications:

Motor Mode: EX1102 KV9000
Configu-ration:9N12P
Stator Diamter:11mm
Stator Length:2mm
Shaft Diameter:Φ1mm
Motor Dimension(Dia.*Len):Φ13.5mm*16mm
Weight(g):2.8g
No.of Cells(Lipo):1S-3S
Flight controller (Frsky version) CRAZYBEE F4FR PRO V2.0 Firmware target: CrazybeeF4FR
(Flysky version) CRAZYBEE F4FS PRO V2.0 Firmware target: CrazybeeF4FS
(DSM2/DSMX version) CRAZYBEE F4DX PRO V2.0 Firmware target: CrazybeeF4DX
(No RX version) CRAZYBEE F4 PRO V2.0 Firmware target: CrazybeeF4DX
MCU:STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board size: 28.5 * 28.5MM
Power supply: 1-3S battery input (DC 3.5-13V)
Built-in 5A(each) Blheli_S 4in1 ESC Dshot600 ready
Frsky version Built-in SPI Frsky receiver with telemetry(D8/D16 switchable)
Flysky version Built-in SPI Flysky receiver with telemetry(AFHDS/AFHDS2A switchable)
DSM2/X Version built-in Serial-based DSM2/DSMX compatible satellite receiver
No RX version need to add external Receiver
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 28A
Current meter scale set to 1175
Built-in 5V 1A Buck / Boost with LC filter
Built-in voltage detection
Onboard 4in1 ESC MCU upgraded to EFM8BB21
Power supply: 1-3S LiPo/LiPo HV (3.5v/13v)
Current: 5A continuous peak 6A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: S_H_50_REV16_7.Hex
Default protocol: DSHOT600
Frsky NON-EU receiver Version SPI BUS receiver
Frsky D8/D16 switchable
Compatible Non EU transmitter both D8 and D16 mode
Channels: 8ch or 16ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 300m
Flysky receiver Version SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 300m
Failsafe support
DSM2/DSMX receiver version Serial bus receiver
Protocol: DSM2/DSMX compatible
Channels:6-9 (Depend on your radio)
No ground interference ( Transmitter and receiver 1 m from the ground): 300m
PNP No RX version No RX version support external serial-bus receiver like xm+, crossfire, S-FHSS etc.
VTX Output power: 25~200mw switchable
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Antenna: RG178 antenna
Frequency: 5.8GHz 5bands 40 channels
With RacebandSmartaudio ready
Weight: 3g
CADDX Turtle V2 Image sensor: 1/2.7″ CMOS sensor
Horizontal: 800TVL
TV system: NTSC/PAL changeable
Video Resolution: 1080P@60fps / 1080P@30fps / 720@60fps
Power Input: DC 4.5-20V
FPV FOV: 155°
Recording FOV: 170°
Mini Illumination: 0.01lux
Image Resolution: 2 Megapixels
Lens: 1.8mm Turbo Eye Lens
Working Current: 380mA@5V/160mA@12V (low consumption)
OSD Menu: Yes (Support Voltage Display)
Video Files: MP4
Audio: Support
Electronic Shutter : PAL : 1/50-100,000 NTSC : 1/60-100,100
S/N Ratio: >60dB (AGC OFF)
Video Output: CVBS
Max Micro SD Card Supported: 8-64GB(need Class 10 or above, recommend Class 10/UHS-I/UHS-II)
Color: Red
Lipo Battery Capacity:300mAh
Voltage:11.4v
Continuous Discharge Rate: 30C
Instantaneous discharge rate: 60C
Size: 65mmx18mmx11mm
Weight: 23gConnector: XT30

      Sale

      Unavailable

      Sold Out