Introducing the Mobula7 1S, a tiny whoop that comes packing speed and efficiency. This drone features one of HappyModel's newest AIO brushless flight controllers that is capable of providing you with a significant RX and VTX range.
FEATURES:
- Compatible with 1S Lipo/LIHV only
- Equipped with the Runcam Nano3
- VTX Power up to 400mW
- Built-in Frsky D8/D16 receiver
REQUIRED:
(1) 1S 450-650mAh LiPo Battery (Not Included)
SPECIFICATIONS:
Flight Controller:
- MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
- Sensor: Either MPU6000, ICM20689, or BMI270 (SPI connection)
- Mount hole size: 25.5mm x 25.5mm
- Power supply: 1S
*This FC is capable to be powered with a 2S battery if using 2S capable motors - Built-in 12A(each) Blheli_S 4in1 ESC
- Built-in Betaflight OSD (SPI Control)
- Built-in 5.8G OpenVTX 0mW~400mW
- Built-in Frsky D8/D16
- Built-in voltage meter sensor: Voltage meter scale 110
- Built-in current meter sensor: Current meter scale 470
ESC:
- Power Supply: 1S LiPo/LiPo HV (This ESC is capable to be powered with a 2S battery if choosing 2S capable motors)
- Current: 12A continuous peak 15A (3 seconds)
- Support BLHeliSuite Programmable
- Factory firmware: Z_H_30_REV16_7.HEX
- Default Protocol: DSHOT300
- Support Bluejay firmware
Receiver:
- SPI BUS Receiver
- CC2500 RF
- Compatible Non-EU transmitter D8/D16 model
- Channels: 8CH
- Transmitter and Receiver 1m from the ground): 200meter Failsafe support
- Supports FrSky D8/ D16, REDPINE, SFHSS
Motors:
- Type: RS0802
- KV: KV20000
- Configuration: 9N12P
- Stator Diameter: 8mm
- Stator Length: 2mm
- Shaft Diameter: Φ1.5mm
- Motor Dimensions(Dia.*Len): Φ10.5mm x 13.5mm
- Weight(g): 0.07oz (2.0g)
- No. of Cells (LiPo): 1S only
Frame:
- Camera: RunCam Nano 3
- Wheelbase: 75mm
- Size: 99mm x 99mm x 40mm
- Weight: 0.85oz (24g)
- Propellers: Gemfan 1610 2-Blade (40mm)
HELPFUL LINKS:
INCLUDES:
(1) HappyModel Mobula7 Brushless Micro FPV Drone
(1) Spare Canopy
(4) Spare Gemfan 1610 2-Blade Propellers (2CW + 2CCW)
(1) Prop Remover Tool
(1) Screwdriver
(1) 4-Port 1S Parallel Charging Board with XT60 Connector & Balance Lead
*To be used with a Li-Po Charger
NOTES:
- When using Bluejay firmware with 48khz, should set startup power to 1100/1200